Camshaft Position Sensor: Service and Repair

CAUTION: Disassembly is prohibited. If anything faulty is found, replace as an assembly unit.




REMOVAL
1. Disconnect CMP sensor coupler.
2. Remove CMP sensor by removing bolt(s).

INSTALLATION

NOTE: After installing CMP sensor, adjust ignition timing. (Refer to "Ignition Timing Check And Adjustment").




1. Install a new O-ring with engine oil applied to CMP sensor.




2. Install CMP sensor to camshaft.
Fit the dog of CMP sensor coupling into the slots of camshaft, when installing. The dogs of CMP sensor coupling are offset. Therefore, if the dogs can not be fitted into the slots, turn the CMP sensor shaft by 180 degree and try again.




3. Tighten CMP sensor bolts.

Tightening Torque
(a):15 Nm (1.5 kg.m, 11.0 lb.ft)

4. Connect CMP sensor coupler.