P (Proportioning) Valve

REMOVAL

CAUTION: Do not allow brake fluid to get on painted surfaces.





1. Clean around reservoir cap and take out fluid with syringe or such.
2. Disconnect brake pipes from P valve.
3. Remove P valve.

WARNING: Never disassemble P valve assembly. If it is found faulty, replace it with new assembly.

INSTALLATION





1. Install P valve.
Tightening Torque
(a): 10 Nm (1.0 kg.m, 7.5 ft. lbs.)
(b): 23 Nm (2.3 kg.m, 17.0 ft. lbs.)
2. Tighten flare nuts to specified torque.
Tightening Torque (c): 16 Nm (1.6 kg.m, 12.0 ft. lbs.)
3. Fill reservoir with specified brake fluid.
4. After installing, check brake pedal play and bleed air from system.
5. Perform brake test and check each installed part for fluid leakage.