Rear

REMOVAL
1. Remove rear axle shaft.





2. In order to remove sensor rotor from retainer ring, grind with a grinder one part of the sensor rotor as illustrated till it becomes thin.

CAUTION:
^ Cover vinyl sheet or the like over wheel bearing so that fine grains from grinding will not enter there.
^ Be careful not to go so far as to grind the retainer ring.





3. Break with a chisel the thin ground sensor rotor, and it can be removed.

INSTALLATION





1. Press-fit sensor rotor as shown.

NOTE: Use care not to cause any damage to outside of retainer ring.

2. Install rear axle shaft.
3. Install brake drum and wheel.