With Scan Tool

DIAGNOSTIC TROUBLE CODE (DTC CLEARANCE)
As A/T DTC is stored in memory of ECM and TCM respectively, be sure to clear it from both ECM and TCM by using either method "A" and "B" or "A" and "C" of the following 3 methods.
A. To clear DTC stored in ECM
- Refer to "Powertrain Management; Computers and Control Systems" for clearance procedure.
B. To clear DTC stored in TCM using SUZUKI scan tool
1. Turn ignition switch OFF.
2. Set mass storage cartridge to SUZUKI scan tool and connect scan tool to DLC.
3. Turn ignition switch ON.
4. Clear DTC according to instructions displayed on scan tool.





C. To clear DTC stored in TCM without scan tool
1. Turn ignition switch OFF.
2. Turn ignition switch ON.
3. After 6 sec. or more, repeat shorting and opening between A/T diag. switch terminal and ground terminal 5 times at about 1 sec. intervals within 10 sec., using service wire.
4. Check TCM that no malfunction DTC remains in memory of it.