Removal and Installation

COMPONENTS

CAUTION:
- Do not remove or adjust throttle stop screw as it is factory adjusted precisely.
- Do not put finger or any other object into MAF sensor and keep away from net.
- Do not remove MAF sensor from throttle body. These spoil its original performance.

REMOVAL




1. Disconnect negative cable at battery.
2. Drain cooling system.
3. Disconnect accelerator cable.
4. Disconnect IAT sensor connector and remove air cleaner outlet hose.




5. Disconnect couplers of TP sensor and MAF sensor.
6. Disconnect coolant hoses and breather hose from throttle body.
7. Remove throttle body from intake manifold.

INSTALLATION




1. Clean mating surfaces and install throttle body gasket to intake manifold.
Use new gasket.




2. Install throttle body to intake manifold and tighten bolts.
3. Connect coolant hoses and breather hose.
4. Connect couplers of TP sensor and MAF sensor.




5. Install air cleaner outlet hose and clamp securely.
6. Connect intake air temperature sensor connector securely.




7. Connect accelerator cable and adjust each cable play to specification.
8. Refill cooling system.
9. Connect negative cable at battery.