Without Scan Tool

DIAGNOSTIC TROUBLE CODE (DTC) CLEARANCE

WARNING:
^ When performing a road test, select a safe place where there Is neither any traffic accident possibility and be very careful during testing to avoid occurrence of an accident.
^ Road test should be carried out with 2 persons, a driver and a tester, on a level road to avoid accident.





After repair or replace malfunction part(s), clear all DTC's by performing described procedure below.
1. Turn ignition switch OFF.
2. Using service wire, connect diag. switch terminal of DIAG-2 connector to diag. output terminal.
3. With connection described in above step 2) maintained, turn ignition switch to ON position.
4. Leave it for longer than 10 seconds.
5. Turn ignition switch OFF and disconnect service wire from DIAG-2 connector.
6. Perform DRIVING TEST and DTC CHECK and confirm that normal DTC (DTC 12) is displayed; not malfunction DTC.

NOTE: If there were wheel speed sensor DTCs (21, 22, 25, 26, 31, 32, 35 and/or 36), repair malfunction part(s) and perform the following procedure before clearing DTC.

1. Drive vehicle 6.5 - 12.5 MPH (10 - 20 km/h).
2. Stop vehicle and turn ignition switch to OFF position.
3. Confirm that there is no wheel speed sensor DTC's as current.