Circuit Test A-2: Malfunction Indicator Light (Mil) Remains Illuminated
NOTE:
With ignition on, PCM energizes main relay. As PCM is supplied ignition power, MIL illuminates. After engine starts, MIL turns off if no malfunction is detected. If a malfunction is detected, MIL will remain illuminated until system is repaired.
- Connect scan tool to Data Link Connector (DLC). Start engine and attempt to retrieve DTCs. If any DTCs are displayed, see DIAGNOSTIC TESTS . If no DTCs are displayed, go to next step.
- Turn ignition off. Disconnect PCM harness connectors. Turn ignition on. If MIL illuminates, repair short to ground in Purple/Yellow wire between MIL bulb and PCM harness connector. If MIL does not illuminate, replace PCM and retest system.