DTC P1450: Barometric Pressure Sensor Circuit Malfunction Or DTC P1451 Barometric Pressure Sensor Performance Problem
- Turn ignition off. Connect scan tool to Data Link Connector (DLC). Turn ignition on. Clear DTC(s). Test drive vehicle and increase engine speed to 3000 RPM in 3rd gear (M/T) or "2" range (A/T). Release accelerator pedal and coast for 5 seconds or more. If necessary, perform test while coasting down a slope where engine can maintain 1600-3000 RPM and fuel-cut condition can be maintained for 5 seconds or more.
- Bring vehicle to a stop and allow engine to idle. Repeat test drive in step 1 2 times. Determine whether either DTC has reset. If DTC P1450 is present, replace PCM and retest system. If DTC 1451 has reset, go to next step.
- Inspect manifold differential pressure (MDP) sensor operation. See steps 1 and 2 in DTC P1408: MANIFOLD DIFFERENTIAL PRESSURE (MDP) SENSOR CIRCUIT MALFUNCTION . If MDP sensor operation is not as specified, repair or replace MDP sensor or circuit as necessary. If MDP sensor operation is as specified, replace PCM and retest system.