Coolant Line/Hose: Service and Repair

REMOVAL
1) Drain cooling system.
2) To remove these pipes or hoses, loosen screw on each pipe or hose clip and pull hose end off.

INSTALLATION
Install removed parts in reverse order of removal procedure, noting the following.
^ Tighten each clamp bolt securely.





^ When installing water outlet pipe to cylinder head, apply sealant to pipe bolt thread and then tighten it (J20 engine only).
Sealant "A": 99000-31110 (SUZUKI BOND No. 1215)
^ Refill cooling system with proper coolant. Refer to Cooling System; Service and Repair.
^ Check each part for leakage.