Shift Cable: Testing and Inspection

REMOVAL
1. Remove console box, if equipped.
2. Remove parking brake lever cover and shift control lever cover.
3. Remove select indicator.
4. Disconnect select cable from selector lever and then from floor bracket.
5. Disconnect select cable from transmission.
6. Disconnect select cable from dash panel.

INSTALLATION
Install select cable by reversing removal procedure. Apply grease to pin and cable joint. Adjusting procedure is as follows.

ADJUSTMENT



1. With loosening cable end nut, shift selector lever to "N" range.
2. Also shift manual shift lever to "N" range.

NOTE: Make sure that nut and cable joint have clearance under above conditions.




3. Turn nut A by hand till it contacts manual select cable joint. Then tighten nut B with wrench.
4. After tightening nut, check for the following.
- Vehicle should not move when pushing vehicle with selector lever shifted to "P" range.
- Vehicle can not be driven in "N" range.
- Vehicle can be driven in "D", "2" and "L" ranges.
- Vehicle can be backed in "R" range.