Inspection and Adjustment
INSPECTION & ADJUSTMENTConfirm the following before inspection and adjustment.
^ Fuel tank is filled with fuel fully.
^ Vehicle is equipped with spare tire, tools, jack and jack handle.
^ Vehicle is free from any other load.
With vehicle in above conditions;
1. Place it on level floor.
2. Push up LSPV lever with finger till it stops and measure length of coil spring ("L" in figure) as it is pulled.
3. Spring length "L" should be the value specified below.
Spring length (between spring ends) "L": 103 mm (4.06 inch)
4. If it isn't, adjust it to specification by changing stay positions as shown in the figure. After adjustment, tighten bolt to specified torque.
Tightening Torque (a): 10 Nm (11.0 kg-m, 7.5 ft. lbs.)
NOTE: Check to make sure that LSPV body and brake pipe joints are free from fluid leakage. Replace defective parts, if any.