P (Proportioning) Valve

REMOVAL

CAUTION: Do not allow brake fluid to get on painted surfaces.





1. Clean around reservoir cap and take out fluid with syringe or such.
2. Disconnect brake pipes from P valve.
3. Remove P valve.

WARNING: Never disassemble P valve assembly. If it is found faulty, replace it with new assembly.

INSTALLATION





1. Install P valve.

Tightening Torque
(a): 10 Nm (1.0 kg-m, 7.5 ft. lbs.)

2. Tighten flare nuts to specified torque.

Tightening Torque (b): 16 Nm (1.6 kg-m, 12.0 ft. lbs.)

3. Fill reservoir with specified brake fluid.
4. After installing, check brake pedal play and bleed air from system. Brake Bleeding
5. Perform brake test and check each installed part for fluid leakage.