Transmission Range (Tr) Switch: Installation
- Shift selector lever to "N" position. Using a flat-blade screwdriver, rotate TR switch joint full clockwise ("P" position). A "click" sound should be heard each time a gear position is selected. Next, rotate TR switch joint counterclockwise 3 clicks to obtain "N" position. See Fig 1.
- Install TR switch on manual shift shaft. Tighten TR switch mounting bolt to 10-17 ft. lbs. (14-23 N.m). Install harness connector. Check for proper installation. Apply parking brake and block vehicle wheels. Check the following:
- With selector lever in "P" position, turn ignition switch to START position. Engine should start.
- With selector lever in "N" position, turn ignition switch to START position. Engine should start.
- With selector lever shifted from "N" to "L" and back to "N", turn ignition switch to START position. Engine should start.
- Shift selector lever from "N" to "P". Check starter for operation.
- Ensure starter and ignition switch operate in "P" and "N" position.
- Without starting engine, turn ignition switch to ON position and shift selector lever to "R" position. Ensure back-up lights illuminate.
Courtesy of SUZUKI OF AMERICA CORP.