Clutch Coil: Installation

To install, reverse removal procedure. Ensure clutch coil is positioned correctly. Ensure NEW snap rings are installed with beveled side facing out. Tighten shaft bolt (or nut) to 11-15 ft. lbs. (15-20 N.m).
Ensure air gap between clutch plate and pulley is 0.016-0.024" (0.41-0.61 mm). If air gap is incorrect, add or remove shim(s) as necessary.

NOTE: On some compressors, it is necessary to use a dial indicator on clutch plate to check air gap. Energize clutch coil and zero dial indicator. De-energize clutch coil and measure air gap. Ensure air gap is as specified.

Fig 1: Exploded View Of Compressor (Nippondenso 10-Cyl. - Typical)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 2: Exploded View Of Compressor (Nippondenso 10PA17C 10-Cyl.)

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

Fig 3: Exploded View Of Compressor (Nippondenso 10PA17C 10-Cyl. Shown; 10PA15 & 10PA20 Are Similar)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.