Valve Body Assembly

VALVE BODY





1. Put check ball in its specified position in transmission case oil passage.
2. Install valve body assembly to transmission case according to following procedure.
1) With transmission fluid applied, place a new transfer plate-to-case gasket, transfer plate and a new transfer plate-to-valve body gasket aligning their bolt holes with those in transmission case.
2) Apply fluid to manual valve and put it in valve body.





3) Put long side of manual valve link into hole in manual valve and then put its short side into hole in select shaft inner lever while holding link and entire valve body by both hands.
4) Place valve body assembly with its bolt holes aligned with those in transmission case.

NOTE: It is recommended that opening of transmission case at select shaft inner lever is to be closed by applying paper towel during installation of valve body so that manual valve link can be prevented from accidental falling in.

5) Tighten 7 bolts to specified torque.





3. Install detent roller assembly with 2 bolts.
4. Place a new gasket with fluid and install oil screen assembly with 3 bolts. Check to ensure that screen is clean.
5. Install reinforcement plate with 6 bolts.
6. Install oil (governor) pressure switch to valve body.
7. Install TCC solenoid valve with oil pipes and tighten with 2 bolts. Wiring is also grounded together.
8. Connect wiring coupler to TCC solenoid valve.
9. Place a new servo piston cover gasket and fasten cover with 4 bolts.

NOTE: Connect pipes to holes in valve body and oil pump securely with O-ring fit to each end of piping opposite from TCC solenoid valve.

Tightening Torque
(a): 19 Nm (1.9 kg-m, 14 ft. lbs.)
(b): 25 Nm (2.5 kg-m, 18 ft. lbs.)