Crankshaft, Engine

Crankshaft runout
Limit on runout 0.06 mm (0.0023 inch)

NOTE: Using a dial gauge, measure runout at center journal. Rotate crankshaft slowly. If runout exceeds its limit, replace crankshaft.





Crankshaft Thrust Play
Standard 0.10 - 0.35 mm (0.0039 - 0.0138 inch)
Limit 0.42 mm (0.0165 inch)

NOTE: Use a dial gauge to read displacement in axial (thrust) direction of crankshaft. If its limit is exceeded, replace thrust bearing with new standard one or oversize one to obtain standard thrust play.





Diameter of journal 57.982 - 58.000 mm (2.2828 - 2.2834 inch)
Limit on out-of-round and taper 0.01 mm 10.0004 inch)

NOTE: Out-of-round A - B, Taper a - b