Overhaul

NOTE: Replace all components included in repair kits to service this master cylinder. Lubricate rubber parts with clean, fresh brake fluid to ease assembly. Do not use lubricated shop air on brake parts as damage to rubber components may result. If any hydraulic component is removed or brake line disconnected, bleed the brake system. The torque values specified are for dry, unlubricated fasteners.









DISASSEMBLY
1. Remove circlip.
2. Remove primary piston.





3. Remove secondary piston by blowing compressed air into hole for rear brake pipe. Be cautious during removal as secondary piston jumps out.

INSPECTION
Inspect as necessary.

NOTE: Before assembling, wash each part in the recommended fluid.

ASSEMBLY
1. Assemble secondary piston as shown on previous page.
2. Install secondary piston assembly into cylinder.
3. Install primary piston in cylinder.





4. Depress, and install circlip. and install.