Disabling Air Bag System (1998 Models)
NOTE:
To release SRS system connector lock, pull spring-loaded sleeve toward stop while holding opposite half of connector. Continue pulling connector sleeve and until connector halves are separated. DO NOT
pull on connector half. See Figure.
- Obtain radio anti-theft code from vehicle owner and write down preset radio frequencies. Ensure ignition is OFF. Disconnect negative battery cable and then positive battery cable. Wait at least 3 MINUTES.
- Remove access panel from under steering wheel. Disconnect 2-pin connector between driver-side air bag and cable reel. See Figure and Figure . When disconnected, air bag connector power and ground terminals are automatically shorted together.
- Remove glove box. Disconnect 2-pin connector between passenger-side air bag and SRS main harness. See Figure and Figure or Figure . When disconnected, air bag connector power and ground terminals are automatically shorted together.
- On 3.5RL, slide front seats fully forward and remove front and rear side trim. Remove front and rear door trim and left and right "B" pillar trim panels. Disconnect 2-pin connector between both front seat belt pretensioners and SRS main harness. See Figure and Figure . When disconnected, seat belt pretensioner connector power and ground terminals are automatically shorted together.
NOTE:
To reconnect SRS connector, push sleeve-side connector half toward pawl-side connector half without touching sleeve. As connector halves are pressed together pawl will push sleeve back. When connector halves are completely connected, pawl will release spring-loaded sleeve and lock connector.