Tail Lamp Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
TAIL LAMP REPLACEMENT REFERENCE
| Callout | Component Name |
|---|---|
| Preliminary Procedure Open the liftgate in order to access the tail lamp access hole covers and screws. |
|
| 1 | Tail Lamp Access Hole Cover Assembly (Qty: 2) |
| 2 | Tail Lamp Screws (Qty: 2)
CAUTION:
Refer to FASTENER NOTICE
. Tightening torque Tighten the screws in the sequence shown to 2.5 N.m (22 lb in) |
| 3 | Tail Lamp Assembly Tip: Pull the lamp assembly rearward, disengage the locator pins and disconnect the electrical connector. |
| 4 | Tail Lamp Locator Pins (Qty: 2) Tip: Use palm pressure to engage the locator pins to quarter panel upon re-installation of the tail lamp. |
| 5 | Rear Quarter Panel Nuts (Qty: 2) |