Installation

1) Before installation, check followings:
- Check O ring for damage and deterioration. Replace if necessary.
- Check to make sure that sensor tooth is free from any metal particles.

2) Install sensor to differential carrier. Apply sealant to sensor as shown and coat O ring with thin film of differential oil.

"A": Sealant 99000-31110





3) Tighten sensor bolt to specified torque.

Tightening Torque
(a): 21 Nm (2.1 kg-m, 15.5 ft. lbs.)

4) Connect connector securely.
5) Install sensor cover.
6) Lowe hoist and connect battery negative cable to battery.