Coast/Set, Resume/Accel and Cancel Switches

COAST/SET, RESUME/ACCEL AND CANCEL SWITCHES
These switches are built in the combination switch assembly.

CAUTION: Never disassemble combination switch assembly. Disassembly will spoil its original functions.

Inspection
1) Disable air bag system.
2) Disconnect connector of COAST/SET, RESUME/ACCEL and CANCEL switches.
3) Check for resistance between "Gr" and "R" wire terminals of disconnected switch connector under each condition below.

All switches released (OFF) : Infinity

CANCEL switch pressed (ON) : About 0 ohms

COAST/SET switch rotated (ON) : 200-240 ohms

RESUME/ACCEL switch rotated (ON) : 820-1000 ohms

If check result is not satisfactory, replace combination switch assembly.

Removal and Installation
Refer to "Combination Switch Removal and Installation".