LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1997 >> X-90 RWD, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Relays & Solenoids >> Relays >> Fuel Pump Relay
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Pump Relay

  1. Turn ignition off. Disconnect negative battery cable. Disconnect relay connector and remove relay. Refer to the FUEL PUMP RELAY LOCATION  table. Using an ohmmeter, check continuity between terminals No. 2 and 4. See Fig 1 or Fig 2 . If continuity is not present, go to next step. If continuity is present, replace relay.
  2. Check resistance between terminals No. 1 and 3. If resistance is 61-75 ohms, go to next step. If resistance is not as specified, replace relay.
  3. Energize relay by applying battery voltage and ground to terminals No. 1 and 3. Check continuity between terminals No. 2 and 4. If continuity is present, relay is okay. If continuity is not present, replace relay.
Fig 1: Identifying Fuel Pump & Main Relay Connector Terminals: Main Relay (Produced In Japan)
G96B09869Courtesy of SUZUKI OF AMERICA CORP.
Fig 2: Identifying Fuel Pump & Main Relay Connector Terminals: Main Relay (Produced In Canada)
G97D06843Courtesy of SUZUKI OF AMERICA CORP.
FUEL PUMP RELAY LOCATION

Application Location
X-90 Passenger Compartment, Attached To Heater Case
scientia non olet · About LEMON Manuals