Symptom Chart "E" - Abs Active Light Malfunctioning
- Turn ignition on. If "ABS ACTIVE" light is illuminated constantly, go to next step. If light is not illuminated constantly, go to step 3).
- Turn ignition switch to LOCK position. Disconnect EBCM harness connectors. Turn ignition switch on. If "ABS ACTIVE" light is illuminated, inspect Blue/Yellow wire between indicator light and EBCM for short to ground. Repair as needed. If circuit is okay, replace instrument cluster printed circuit board. If "ABS ACTIVE" light is not illuminated, replace EBCM.
- Determine is "BRAKE" and "ABS" lights are functioning correctly. If either light is not functioning correctly, inspect and repair applicable circuits. If both lights are functioning correctly, go to next step.
- Turn ignition switch to LOCK position. Disconnect EBCM and instrument harness connectors. Check continuity of Blue/Yellow wire between terminal No. 7 on instrument cluster 16-pin harness connector and terminal No. 6 on EBCM 24-pin harness connector. Repair as needed. If circuit is okay, inspect "ABS ACTIVE" light bulb. Replace as needed. If bulb is okay, inspect instrument cluster printed circuit board. Replace as needed. If circuit board is okay, replace EBCM.