Camshaft Position Sensor: Adjustments
Signal Rotor Air Gap1. Remove distributor cap and rotor.
2. Using thickness gauge, measure air gap, between signal rotor tooth and CMP sensor (generator).
Signal rotor air gap "a": About 0.2 mm (about 0.008 in.)
3. If gap is out of specification, loose CMP sensor (signal generator) securing screws. Using blade (-) screw driver, move CMP sensor (generator) and adjust gap to specification. After adjustment, tighten securing screws and recheck gap.
NOTE: Check to make sure that CMP sensor (signal generator)
tooth is free from any metal particles.
4. Install distributor cap and rotor.