Abs Fail-Safe Relay
- Turn ignition off and disconnect negative battery cable. Remove ABS fail-safe relay from engine compartment fuse/relay block and check resistance between relay terminals. Resistance between relay terminals "A" and "C" should be 70-90 ohms at 68°F (20°C). See Fig 1
. Continuity should exist between relay terminals "B" and "E". No continuity should exist between relay terminals "D" and "E".
- Using jumper wires, apply battery voltage to relay terminals "A" and "C". Continuity should now exist between relay terminals "D" and "E". Replace ABS fail-safe relay if it does not test as specified.
Courtesy of SUZUKI OF AMERICA CORP.