4WD

REMOVAL
1. Turn ignition switch "OFF" and disconnect battery negative cable.
2. Remove rear center console box.
3. Remove parking brake lever bolts (A).

NOTE: Loosen only bolt (B).

4. Remove G-sensor with bracket from floor.
5. Disconnect connector from sensor.

CAUTION:
^ Do not separate sensor and bracket. It will lead to erroneous assembly.
^ Sensor must not be dropped or shocked. It will affect its original performance.

INSTALLATION
1. Connect connector to sensor securely.





2. Install G-sensor with bracket and parking lever assembly onto floor so that arrow mark directs vehicle forward and torque bolt (a) to 23 Nm (17 ft. lbs.)
3. Install rear console box.