DTC P1500: Engine Starter Signal Circuit Malfunction

Turn ignition off. Disconnect PCM harness connectors. Turn ignition on. On models with 3-speed automatic or manual transmission, measure voltage between ground and PCM harness connector "C", terminal No. 2 (Black/Yellow wire). On models with 4-speed automatic transmission, measure voltage between ground and PCM harness connector "D", terminal No. 2 (Black/Yellow wire). If reading is 6-12 volts while cranking engine, check for poor connections at PCM. If connections are okay, replace PCM. If reading is not a specified, repair open Black/Yellow wire.