Common Specs & Procedures
SIDEKICK COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | A/C SYSTEM SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | N/A | ||
| Battery | |||
| 1.6L | CAPACITIES | ||
| 1.8L | CAPACITIES | ||
| Brakes | |||
| Bleeding Sequence | |||
| With ABS | BLEEDING BRAKE SYSTEM for 1.6L | ||
| BLEEDING BRAKE SYSTEM for 1.8L | |||
| Without ABS | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | |||
| Service Specifications | DISC BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drum Brakes | |||
| Service Specifications | DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | |||
| 1.6L | Refer to GENERATOR OUTPUT SPECIFICATIONS located under GENERATOR OUTPUT . | ||
| 1.8 | Refer to GENERATOR OUTPUT SPECIFICATIONS located under GENERATOR OUTPUT . | ||
| Torque | |||
| 1.6L | TORQUE SPECIFICATIONS | ||
| 1.8L | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Drive Belt Routing | BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 12.5 psi (.88 kg/cm2 ) | ||
| Thermostat R & I | |||
| 1.6L | THERMOSTAT | ||
| 1.8L | N/A | ||
| Water Pump R & I | |||
| 1.6 L | WATER PUMP | ||
| 1.8L | WATER PUMP | ||
| Engine Mechanical | |||
| 1.6L | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | Normal oil pressure is 46.9-61.2 psi (3.3-4.3 kg/cm2 ) at 4000 RPM. | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 1.8L | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | Normal oil pressure is 55.5-66.8 psi (3.9-4.7 kg/cm2 ) at 4000 RPM. | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | |||
| 1.6L | 55-59 Ft. Lbs. (75-80 N.m) | ||
| 1.8L | 52 Ft. Lbs. (70 N.m) | ||
| Fuel System | |||
| 1.6L | |||
| Pressure Specification | FUEL PUMP | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE TEST | ||
| Fuel Filter Location | N/A | ||
| Fuel Filter R & I | N/A | ||
| 1.8L | |||
| Pressure Specification | FUEL PUMP | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE TEST | ||
| Fuel Filter Location | N/A | ||
| Fuel Filter R & I | N/A | ||
| Ignition | |||
| 1.6L | |||
| Firing Order & Cylinder Identification | FIRING ORDER | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER | ||
| 1.8L | |||
| Firing Order & Cylinder Identification | N/A | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | N/A | ||
| Spark Plug | |||
| 1.6L | SPARK PLUGS | ||
| 1.8L | SPARK PLUGS | ||
| Starting | |||
| Specification | |||
| 1.6L | STARTER SPECIFICATIONS | ||
| 1.8L | STARTER SPECIFICATIONS | ||
| Torque | |||
| 1.6L | TORQUE SPECIFICATIONS | ||
| 1.8L | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | |||
| Front | TORQUE SPECIFICATIONS | ||
| Rear | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 69 Ft. Lbs. (95 N.m) | ||