Combination Switch Test
Disconnect combination switch connectors. Using an ohmmeter, check continuity across switch terminals with switch in indicated position. See COMBINATION SWITCH CONTINUITY table. See Fig 1 . If continuity is not as specified, replace necessary components.
COMBINATION SWITCH CONTINUITY
| Switch Position | Terminal-To-Terminal (Wire Color) | |||
|---|---|---|---|---|
| Turn Signal & Hazard | ||||
| RH Turn Signal | YEL & YEL/WHT, GRN & GRN/YEL | |||
| LH Turn Signal | YEL & YEL/WHT, GRN & GRN/RED | |||
| Neutral | YEL & YEL/WHT | |||
| Dimmer & Passing | ||||
| Low Beam | RED/WHT & WHT/BLK | |||
| High Beam | RED & WHT/BLK | |||
| Passing | WHT/BLK, RED & RED/BLK | |||
| Headlights | ||||
| Parking | WHT & GRN | |||
| Lights | WHT, RED, & GRN | |||
| Off | (1) | |||
| Horn | BLU/BLK & Ground | |||
|
||||