Input Shaft: Service and Repair

NOTE: Refer to Overhaul for the disassembly procedure. Service and Repair

1. Take out oil seal (1) from input shaft oil seal retainer (2) and install new oil seal with Special Tool (A) 09913-84510 and hammer up to case surface. Unless oil seal is leaky or its lip is excessively hardened, replacement is unnecessary.





2. Remove circlip of input shaft (1) and pull out bearing (2) with puller (3) and press as necessary.

NOTE: Sealed bearing must not be washed. Replace it with new one when required.





3. When installing bearing (1), bring it so that its groove for circlip is in the front and press-fit with Special Tool (B) 09925-18010 and press.





4. After fitting circlip (1), air-blow lubrication oil hole.