Clutch Switch: Adjustments

1. Apply parking brake firmly and place gear shift control lever in neutral position.
2. Disconnect lead wire coupler beside the pedal bracket.
3. Loosen lock nut and screw the switch out.
4. Depress clutch pedal all the way to the floor, and then return it back 20-30 mm (0.8-1.2 inch) along its travel from the floor.
Travel "a": 20-30 mm (0.8-1.2 inch)
5. Connect ohmmeter to the switch, and slowly screw in until it is ON. Hold the switch at this position, and tighten lock nut to specification.
6. Connect lead wire.
Tightening Torque (a) 13 Nm (114 inch lbs.)

CAUTION: When clutch pedal is fully depressed, clearance "b" (remaining switch stroke) should be more than 2 mm (0.08 inch) with this adjustment. Travel "a " more than specification may cause "b" to be less than 0.5 mm (0.02 inch) and consequential damage of switch bracket.