Drive Belt Inspection

WARNING: Disconnect negative cable at battery before checking and adjusting belt tension.





WATER PUMP BELT
1. Remove engine under cover of right side from vehicle body.
2. Inspect belt for cracks, cuts, deformation, wear and cleanliness. Replace, if necessary.
3. Check pump belt for tension and adjust it as necessary.

Water pump belt tension "a": 6 - 8 mm (0.24 - 0.32 inch) deflection under 10 kg or 22 lbs. pressure.

NOTE: When replacing belt with a new one, adjust belt tension to 5 - 7 mm (0.20 - 0.27 inch).





A/C COMPRESSOR AND/OR POWER STEERING PUMP DRIVE BELT (IF EQUIPPED)
1. Detach air cleaner assembly from vehicle body and shift its position.
2. Inspect belt for wear, deterioration and tension. Replace or adjust, if necessary.

A/C compressor and/or power steering pump drive belt tension "a": 8 - 10 mm (0.32 - 0.39 inch) deflection under 10 kg or 22 lbs. pressure.