Disassembly

1. For ease in servicing cylinder head, remove distributor gear case, intake manifold with throttle body and exhaust manifold from cylinder head.
2. Remove camshaft as previously outlined and remove rocker arms and washers by pulling its shaft out to transmission side.





3. Using special tool (Valve lifter), compress valve springs and then remove valve Dotters by using special tool (Forceps) as shown.

Special Tool, or equivalent
(A): 09916-14510
(B): 09916-14910
(C): 099-16-84510

4. Release special tool, and remove spring retainer and valve spring.
5. Remove valve from combustion chamber side.





6. Remove valve stem oil seal from valve guide, and then valve spring seat.

NOTE: Do not reuse oil seal once disassembled. Be sure to use new oil seal when assembling.





7. Using special tool (Valve guide remover), drive valve guide out from combustion chamber side to valve spring side.

Special Tool, or equivalent (A): 09916-44910

NOTE: Do not reuse valve guide once disassembled. Be sure to use new valve guide (Oversize) when assembling.

8. Place disassembled parts except valve stem seal and valve guide in order, so that they can be installed in their original position.