LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1996 >> Swift Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Circuit Tests >> DTC P0141 - Ho2S No. 2 Heater Circuit Malfunction
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0141 - Ho2S No. 2 Heater Circuit Malfunction

  1. Start engine and let idle. Using a voltmeter, backprobe between ground and PCM harness connector "A", terminal No. 4 (Pink wire). Reading should be greater than 10 volts. Increase engine speed to greater than 2000 RPM and hold for 2 minutes. Reading should be less than 1.9 volts. If reading is not as specified, go to next step. If reading is as specified, check for an intermittent problem. See TESTS W/O CODES article.
  2. Turn ignition off. Disconnect HO2S No. 2 harness connector. Using an ohmmeter, measure resistance between Black/White wire and Pink wire of HO2S No. 2 connector at sensor. If resistance is 11.7-15.6 ohms at 68°F (20°C), go to next step. If resistance is not as specified, replace HO2S No. 2. Retest system.
  3. Check Pink wire between HO2S No. 2 and PCM for an open or short to ground. Repair as necessary. If wire is okay, replace PCM. Retest system.
scientia non olet · About LEMON Manuals