LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1996 >> Sidekick JS, 4D Utility, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heater System >> Removal & Installation >> Control Panel & Blower Motor Switch >> Removal & Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation

  1. Disconnect negative battery cable. Disable air bag system. AIR BAG RESTRAINT SYSTEM article in the ACCESSORIES/SAFETY EQUIPMENT section. Pull off control lever knobs. Remove heater control lever garnish. Remove heater control face panel.
  2. Remove glove box. Remove ashtray and center garnish. Remove lower left dash trim panel and knee bolster. Remove center glove box. Disconnect control cables from blower motor case and heater case.
  3. Remove control panel screws. Disconnect electrical connector from control panel blower motor switch. Remove control panel. Remove blower motor switch from control panel and check continuity. See BLOWER MOTOR SWITCH  under TESTING.
  4. To install, reverse removal procedure. Ensure all control levers operate smoothly. If lever does not operate smoothly, adjust cable clamp position. See ADJUSTMENTS  .
scientia non olet · About LEMON Manuals