Gearshift Cable: 3-Speed
- Remove center console covers. Place gearshift in Neutral.
Looking at gearshift assembly from passenger side, note 2 holes on
rear of lever detent bracket, below level of console cover.
- Both holes should be aligned. Install a pin in hole to hold
gearshift in Neutral. Loosen adjusting nut and lock nut. See Fig 1. Ensure shift lever
on transmission is in Neutral.
- Tighten adjusting nut and then lock nut. Remove pin from
gearshift assembly. Ensure gearshift operates properly in all gear
ranges. Install console covers.
Courtesy of SUZUKI OF AMERICA CORP.