Direct Clutch: Disassembly
- Prior to disassembly, place direct clutch drum on center support. Using a dial indicator and compressed air, measure direct clutch piston stroke while applying 57-114 psi (4-8 kg/cm2 ) to OD case oil hole. See Figure . Piston stroke should be .008-.069" (.20-1.75 mm). If piston stroke is not as specified, inspect discs. Remove direct clutch from center support.
- Remove snap ring, flange, discs and plates. See Figure . Note location and number of components. Using appropriate spring compressor, compress piston return spring and remove snap ring. Remove piston return spring.
- Place direct clutch drum on center support. Hold direct clutch piston with hand, and apply compressed air to center support to remove direct clutch piston. Apply compressed air to appropriate hole in center support to remove piston subassembly from direct clutch piston. See Figure . Remove "O" rings from piston(s).