LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1996 >> Sidekick JS, 2D Utility, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Anti-Lock Brake System) >> Diagnosis & Testing >> Clearing Diagnostic Trouble Codes >> Using Voltmeter Or ABS Warning Light
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Using Voltmeter Or ABS Warning Light

WARNING: This page is about a different variant/trim than selected.
  1. If vehicle is equipped with ABS control module part number 33940-77E00, go to step  3 . If vehicle is equipped with ABS control module part number 33940-77E01 AND a wheel speed sensor DTC was present (DTC 21, 22, 25, 26, 31, 32, 35 or 36), go to next step. If vehicle is equipped with ABS control module part number 33940-77E01 AND a wheel speed sensor DTC was not present (DTC 21, 22, 25, 26, 31, 32, 35 or 36), go to step  3 .
  2. Road test vehicle at 6.5-12.5 MPH over level road surface. Stop vehicle and turn ignition off. Turn ignition back on and observe ABS warning light. If ABS warning light goes off 2 seconds after ignition is turned on, go to next step. If ABS warning light does not go off 2 seconds after ignition is turned on, repeat repair procedure.
  3. Turn ignition off. Using a jumper wire, connect Black diagnostic connector No. 2 diagnostic switch terminal to diagnostic output terminal. See Figure . Turn ignition on for at least 10 seconds. Turn ignition off and disconnect jumper wire. Perform DTC check and confirm DTC 12 (system okay) is displayed and no other codes are stored. See RETRIEVING DIAGNOSTIC TROUBLE CODES  .
scientia non olet · About LEMON Manuals