DTC P0131 - Ho2S No. 1 Circuit Low/DTC P0132 - Ho2S No. 1 Circuit High Input
NOTE:
If any other DTCs besides DTC P0131 or P0132 are set, diagnose those DTCs first.
- Connect scan tool to Data Link Connector (DLC). Start engine and allow it to reach normal operating temperature. Increase engine speed to 2000 RPM and release to idle. Repeat 5-6 times continuously while monitoring HO2S No. 1 parameter on scan tool. If display reading varies from less than 0.3 volt to greater than 0.6 volt, check for an intermittent problem. See TESTS W/O CODES article. If display reading is not a specified, go to next step.
- Check White wire and Orange wire between HO2S No. 1 and PCM for open or short. Repair as necessary. If wires are okay, replace HO2S No. 1. Retest system.