Od/Off Indicator Flashes
- Retrieve DTCs using "Flash Code" method. See FLASH CODE METHOD under RETRIEVING TROUBLE CODES . If OD/OFF indicator indicates a DTC, perform a visual inspection. See PRELIMINARY CHECK . If OD/OFF indicator does not indicate a DTC, go to next step.
- Turn ignition off. Remove jumper wire from diagnostic connector. Turn ignition on. Using a DVOM, measure voltage between ground and diagnostic switch terminal (Green/Red wire) at diagnostic connector No. 2. See Figure. If reading is 4-6 volts, go to next step. If reading is not as specified, repair Green/Red wire for a short to ground. Retest system.
- Check TCM ground circuit. See step 2 in TCM POWER & GROUND CIRCUIT under TCM CIRCUIT CHECK. Repair as necessary. If ground circuit is okay, substitute TCM with a known-good unit. Retest system.