Park/Neutral Position Switch (A/T)
NOTE:
Park/neutral position switch may also be referred to as transmission range switch.
- Apply parking brake. Disconnect electrical connector at park/neutral position switch, located on top of transaxle, just below shift cable.
- Note terminal identification on park/neutral position switch. See Figure . Using ohmmeter, check for continuity between specified terminals with shift lever in specified positions. See PARK/NEUTRAL POSITION SWITCH SPECIFICATIONS table. If proper continuity does not exist, adjust or replace switch as necessary.
PARK/NEUTRAL POSITION SWITCH SPECIFICATIONS
| Lever Position | Continuity Between Terminals | |
|---|---|---|
| 1995 | ||
| Park | 5 & 6; 8 & 9 | |
| Reverse | 4 & 9 | |
| Neutral | 5 & 6; 7 & 9 | |
| Drive | 3 & 9 | |
| 2 | 2 & 9 | |
| Low | 1 & 9 | |
| 1996 | ||
| Park | 5 & 6; 8 & 9 | |
| Reverse | 1 & 8 | |
| Neutral | 5 & 6; 8 & 10 | |
| Drive | 2 & 8 | |
| 2 | 3 & 8 | |
| Low | 4 & 8 | |