Transmission Range (Tr) Switch
Turn ignition off. Disconnect TR switch harness connector located on side of transaxle. Using a DVOM, check for continuity between specified TR switch terminals in specified gear selector lever position. See Fig 1. See TR SWITCH CONTINUITY table. Ensure continuity is not present between any terminal and transaxle case in any position. Replace TR switch if continuity is not as specified.
TR SWITCH CONTINUITY
| Lever Position | Continuity Between Terminals No. |
|---|---|
| "P" | 5 & 6, 8 & 9 |
| "R" | 1 & 8 |
| "N" | 5 & 6, 8 & 10 |
| "D" | 2 & 8 |
| "2" | 3 & 8 |
| "L" | 4 & 8 |