LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1996 >> Esteem GL, Automatic >> Repair and Diagnosis >> Engine Performance >> Sensor Range Charts >> Engine Controls - Sensor Operating Range Charts >> Sensor Operating Range Charts
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Sensor Operating Range Charts

CAMSHAFT POSITION (CMP) SENSOR RESISTANCE (1)

Application Temperature °F (°C) Ohms
Esteem 14-122 (-10-50) 185-275
" 122-212 (50-100) 240-325
(1) Measured at sensor while disconnected with ignition off.
CRANKSHAFT POSITION (CKP) SENSOR RESISTANCE

Application Ohms @ 68°F (20°C)
Esteem 360-460
ENGINE COOLANT TEMPERATURE (ECT) SENSOR RESISTANCE

Temperature °F (°C) Ohms
32 (0) 5740
68 (20) 2280-2610
104 (40) 1150
140 (60) 584
176 (80) 303-326
INTAKE AIR TEMPERATURE (IAT) SENSOR RESISTANCE

Temperature °F (°C) Ohms
32 (0) 5880
68 (20) 2210-2690
104 (40) 1140
140 (60) 580
176 (80) 290-350
CAUTION: Damage to MAP sensor will occur if connections are made incorrectly.
MAP SENSOR OUTPUT VOLTAGE (OFF-VEHICLE)

Altitude (Feet) Vacuum (In. Hg) (1)(2) Output Voltage
0-2000 28-30 3.1-3.6
2001-5000 25-28 2.8-3.4
5001-8000 22-25 2.6-3.1
8001-10,000 20-22 2.4-2.9
(1) MAP sensor output voltage is tested with three 1.5-volt batteries connected in series (output 4.5-5.0 volts). Positive lead of batteries is connected to "Vin" terminal. Negative lead of batteries is connected to "Ground" terminal. Check output voltage between "Vout" and "Ground" terminals.
(2) Voltage should reduce when up to 15 in. Hg of vacuum is applied to MAP sensor.
MAP SENSOR OUTPUT VOLTAGE (ON-VEHICLE) (1)

Vacuum (In. Hg) Scan Tool Display (kPa)
0 100
8 73
20 33
(1) With scan tool installed, ignition on, and specified vacuum applied to MAP sensor.
CAUTION: Blowing compressed air through mass airflow sensor will damage it.
THROTTLE POSITION (TP) SENSOR RESISTANCE

Application Ohms
Between Terminals "A" & "B"
With .012" (.30 mm) Clearance At Stop Screw 0-3000
With .024" (.60 mm) Clearance At Stop Screw Infinity
Between Terminals "A" & "D" 2870-5330
Between Terminals "A" & "C"
At Idle 130-10,930
At Wide Open Throttle 2020-14,640
VEHICLE SPEED SENSOR (VSS) RESISTANCE

Application Ohms
Steem (1) *
(1) With ohmmeter connected to vehicle speed sensor terminals, ohmmeter should alternate between zero and infinity 4 times per sensor shaft revolution.
scientia non olet · About LEMON Manuals