LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1995 >> Swift Standard >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Diagnosis - ECC 3-Speed >> Diagnostic Testing >> DTC 23: Open 2ND Brake Solenoid Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC 23: Open 2ND Brake Solenoid Circuit

NOTE: Removal of transaxle oil pan may be necessary to complete the following diagnostic procedure.
  1. Perform TCM DIAGNOSTIC CIRCUIT CHECK. Ensure ignition is on and gear selector is in "D" position. Disconnect solenoid harness connector. See Figure. Using a DVOM, measure voltage between chassis ground and solenoid harness connector terminal No. 1 (Orange/Green wire). If battery voltage is present, go to step 3). If battery voltage is not present, go to next step.
  2. Measure voltage (backprobe) between chassis ground and TCM 14-pin harness connector terminal No. 6 (Orange/Green wire). See Figure. If battery voltage is present, repair open in Orange/Green wire between TCM and solenoid. If battery voltage is not present, check for poor TCM harness connection. Repair as necessary. If connection is okay, replace TCM and retest system.
  3. Using a DVOM, measure resistance between chassis ground and solenoid connector terminal No. 1 (Yellow wire). If resistance is 10-15 ohms, check for poor connection at solenoid. Repair as necessary. If connection is okay, replace TCM and retest system. If resistance is not as specified, go to next step.
  4. Move gear selector to "P" position. Turn ignition switch to LOCK position. Disconnect 2nd brake solenoid harness connector. Using a DVOM, measure resistance of Yellow wire between solenoid and solenoid harness connector. If resistance is less than .5 ohm, replace solenoid. If resistance is not as specified, repair open in Yellow wire. Retest system.
scientia non olet · About LEMON Manuals