Throttle Position Sensor: Service and Repair

Removal
1. Disconnect battery negative cable at battery.
2. Remove air cleaner assembly.
3. Disconnect coupler from TP sensor.
4. Remove TP sensor from throttle body.

Installation





1. Install TP sensor to throttle body. Fit TP sensor to throttle body in such way that its adjusting holes are a little away from TP sensor screw holes as shown in left figure and turn TP sensor clockwise so that those holes align. Then hand-tighten TP sensor screws.
2. Connect coupler to TP sensor securely.
3. Install air cleaner assembly.
4. Connect battery negative cable to battery.
5. Adjust installation angle of TP sensor according to procedure described in Throttle Position Sensor - Adjustments.