DTC 11: Shorted Wheel Speed Sensor
- Turn ignition off. Disconnect wheel speed sensor connector and measure resistance across wheel speed sensor terminals. If resistance is less than 1000 ohms, replace wheel speed sensor.
- If resistance is 1000-2000 ohms, disconnect RWAL ECM connector. Leave wheel speed sensor disconnected. Measure resistance between RWAL ECM terminal No. 10 and ground. See Figure. If resistance is 20 k/ohms or less, repair short to ground in Orange wire.
- If resistance is more than 20 k/ohms, measure resistance between RWAL ECM harness connector terminals No. 9 and 10. If resistance is more than 20 k/ohms, replace RWAL ECM. If resistance is less than 20 k/ohms, repair short between Orange and White wires.