Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The transaxle bolts must be torqued in a mandatory sequence.

Fig 1: Identifying Front Transaxle Mount (2 Of 2)

Courtesy of SUZUKI OF AMERICA CORP.

CAUTION: Refer to FASTENER NOTICE .

Install the front transaxle mount (2) and transaxle bolts (1).
Tightening torque

Tighten the bolts to 90 N.m (66 lb ft) .

Fig 2: Identifying Front Transaxle Mount Thru Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Hand tighten the front transaxle mount thru bolt.
NOTE: The front and rear transmission mounts must be allowed to settle with the thru bolts loosened.
Loosen the rear trans mount thru bolt.
Tighten the transmission mount thru bolts in the following order.
Tightening torque
1. Tighten the rear bolt to 100 N.m (74 lb ft) .
2. Tighten the front bolt to 100 N.m (74 lb ft) .
Lower the vehicle.