Clutch Pedal Switch (M/T)
- Apply parking brake. Place shift lever in Neutral. Disconnect electrical connector from clutch pedal switch, located near top of clutch pedal. See Fig 1 .
- Loosen lock nut on clutch pedal switch. Unscrew clutch pedal switch from mounting bracket. Connect ohmmeter between electrical terminals on clutch pedal switch for checking switch continuity.
- Fully depress clutch pedal. Slowly release clutch pedal until the distance from top of pedal pad on clutch pedal to the floor is 1.0" (25 mm). Hold clutch pedal in this position.
- Slowly screw clutch pedal switch into mounting bracket until continuity exists between electrical terminals on clutch pedal switch. Hold clutch pedal switch and tighten lock nut to specification. See TORQUE SPECIFICATIONS
.CAUTION: Proper plunger distance must exist between tip of plunger on clutch pedal switch and end of clutch pedal switch when clutch pedal is fully depressed to prevent damage to clutch pedal switch or mounting bracket.
- Fully depress clutch pedal. Ensure plunger distance between tip of plunger on clutch pedal switch and end of clutch pedal switch is within specification. See PLUNGER DISTANCE SPECIFICATIONS
table. See Fig 1
.PLUNGER DISTANCE SPECIFICATIONS
Application In. (mm) Sidekick .08 (2.0) - Readjust clutch pedal switch if proper plunger distance does not exist. Remove ohmmeter. Reinstall electrical connector.