Removal & Installation
WARNING: This page is about a different car, the 1998 Suzuki Sidekick, 1997 Suzuki Sidekick, and 1996 Suzuki Sidekick. However, it is still accessible from the selected car via links, so may be relevant.
Remove wheel hub with wheel speed sensor rotor. See appropriate FRONT SUSPENSION article in SUSPENSION. Mount hub in vise. Using flat-head screwdriver, pry rotor ring off hub assembly gradually and evenly. See Fig 1 . DO NOT attempt to pull rotor ring out partially to prevent damage to ring. To install, press rotor ring onto hub using a pipe with inside diameter of 3.55-3.77" (90-96 mm). Outside diameter of pipe should not contact teeth on rotor ring. See Fig 2 . To complete installation, reverse removal procedure and tighten all fasteners to specification.