LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1995 >> Samurai >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.3L 4-CYL VIN [3] >> Removal & Installation >> Engine >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation: Engine: Removal

  1. Release fuel pressure. See FUEL PRESSURE RELEASE  . Disconnect battery cables. Mark and remove hood. Remove warm air hose. Disconnect breather hose from air cleaner case. Remove air cleaner case from throttle body and air inlet hose.
  2. Mark all remaining connectors and disconnect from throttle body and intake manifold. Disconnect accelerator cable from throttle body. Disconnect and mark wires from starter motor and generator terminals. Mark and disconnect vacuum hoses.
  3. Disconnect fuel supply and return hoses from throttle body. Disconnect wire connector from oil pressure sending unit and oxygen sensor. Disconnect wire connector from back-up light switch and 5th gear switch.
  4. Disconnect distributor primary wires at distributor. Remove high tension wire from ignition coil. Drain radiator. Disconnect hoses from thermostat cap and inlet pipe. Remove cooling fan and clutch.
  5. Remove fan shroud and radiator. Disconnect brake booster vacuum hose. Remove 4 bolts fastening gearshift No. 2 lever boot, and move boot upward. Move gearshift No. 1 to upper side of shift lever.
  6. Loosen 3 bolts on gearshift lever case, and remove shift lever from lever case. Raise vehicle. Disconnect exhaust pipe from exhaust manifold. Disengage clutch cable from clutch release lever. Drain transmission oil.
  7. Remove drive shaft connecting transmission case to transfer case. Attach hoist to hooks provided on engine. One hook is mounted on each side of engine.
  8. Remove exhaust center pipe mounting bracket and 4 transmission mount bolts. Remove pipe connected to chassis under transmission. Lower vehicle. Remove 4 bolts securing right and left engine mounting brackets.
  9. Ensure all hoses, electrical wires and cables are disconnected. Remove engine. Remove lower clutch cover. Separate engine from transmission (if necessary).